Construction of Dragonfly has been paused as I am in the process of moving house.
Add new comment
Smaller version of Dragonfly with upgraded & 3D printed parts.
| Type | Tricopter | Home made |
|---|---|---|
| Receiver | LemonRX | 6 channel |
| Ch 1 | Roll | |
| Ch 2 | Pitch | |
| Ch 3 | Lift | |
| Ch 4 | Yaw | |
| Ch 5 | Mode | Acro / Self-Levelling / Self-Levelling Mix |
| Ch 6 | Lights | |
| Flight Controller | KK 2.1.5 Hard Case | |
| Battery | 3S LiPo | |
| Motors | FC 2822 1200kv | |
| Circumdiameter | ||
| Takeoff Weight |
- Details
I have started building a second Dragonfly tri-copter.
Dragonfly 2 will be smaller than the original Dragonfly as the spars are made from old cutoffs. The motor mounts and tail assembly are 3D printed (thanks Bill for the printing!).
The video below shows a servo test of the tail assembly. The motor has been left off so that the servo & linkage can be seen clearly.