Just dug out the Micro-X to see if it was still working,
I successfully bound it to my Radiomaster TX16S and it still flies. The battery only lasts about 2 minutes now though but that's not bad for sitting on a shelf for 4 years.
| Hardware | Comments | |
|---|---|---|
| Frame: | Micro X | |
| Source: | ||
| Circumdiameter (without props): | 112mm | |
| Take off weight: | ||
| Flight controller: | MultiWii | |
| Receiver: | DSM 2 | |
| ESC: | Brushed | |
| Motors: | Brushed | |
| GPS: | None. | |
| LiDAR & Optical flow: | None | |
| VTx: | N/A | |
| FPV Camera: | N/A | |
| HD Camera: | N/A |
Just dug out the Micro-X to see if it was still working,
I successfully bound it to my Radiomaster TX16S and it still flies. The battery only lasts about 2 minutes now though but that's not bad for sitting on a shelf for 4 years.
When I went to try out my new Turnigy Micro-X quad I found that it would not arm. Searching the internet I discovered that to arm the Micro-X you needed to hold full left rudder for a few seconds. The red LEDs at the from of the Micro-X would then light up to show that the copter is armed.
I successfully bound the Micro-X with my Jumper T16 pro V2 transmitter but the quad wouldn't arm.
I tried a number of things including:
I thought then that the Micro-X might be faulty and contacted Hobby King. They suggested a number of options, none of which worked.
They then asked what transmitter I was using. This made me think of trying another transmitter. I tried my old Spektrum DX7s transmitter and it seemed to work OK?